As a truck driver, many times you may drive in an unfamiliar place. If your truck is a little wrong at this time, you dare not continue to move forward, you can’t just sit around, wait for others come to help you and put you in a dilemma. What should you do?
1. Broken tubing
When the tubing is broken, you can find a rubber or plastic tube that fits the tubing diameter. If the sleeve is not tight enough, tie the ends with iron wire to prevent oil leakage.
2. Tubing rupture
When the tubing breaks, wipe the cracked area clean, apply soap, wrap the tubing or tape around the cracked tubing, tie it with iron wire, and then apply a layer of soap.
3. Leakage of the oil pipe joint
It can be wrapped around the lower edge of the horn with cotton yarn, and then tighten the tubing nut and the tubing joint; you can also chew bubble gum or maltose into a paste and apply it to the seat of the tubing nut. After it has dried and solidified, it will play a sealing role.
4. Oil and water leakage
According to the size of the trachoma, the fuse for an electrician with corresponding specifications can be selected, and it can be smashed into the trachoma with a hand hammer to eliminate oil leakage and water leakage.
5. Fuel tank damage
When the truck is in use, it is found that the fuel tank is leaking. You can wipe the oil spill clean, apply soap or bubble gum to the oil leak, and temporarily block it; use epoxy resin adhesive to repair it better
6. Rupture of the precipitation cup
Put the sedimentation cup in and out of the oil pipe sleeve with a rubber cloth tube or a plastic tube so that the oil can pass straight through without passing through the sedimentation cup.
7. The inlet and outlet hoses are broken
When the rupture is not large, the leaked area can be wrapped up with a cloth coated with soap; if the rupture is large, the hose can be cut off, a bamboo pipe or iron pipe is placed in the middle, and tied with iron wire.
8. Valve spring is broken
The broken spring can be removed and the broken two sections can be installed in reverse to use. If the spring is broken into several knots, you can remove the adjusting screws of the inlet and exhaust valves of the cylinder to keep the valve closed and stop the cylinder.
9. The fan belt is broken
You can tie the broken belt with iron wire in series or drive the car away by starting, stopping, and stopping.
-----------
Tips :
Remember these 9 emergency methods, in many strange cities, you are not afraid to run any further!
Leave a Reply